RailRider Steps up & Delivers!
Thanks a lot for the super custom 48 inch Sissy Bar, RailRider. Well, I did it, I managed to make an excellent pair of sissy bar clamps for the hole-less sissy bar that you made for me. I made them...
View ArticleRe: RailRider Steps up & Delivers!
Hey, looks great. Realy like the bullets in the ends.
View ArticleRe: RailRider Steps up & Delivers!
Looks great, If you remove the button it usually wont snap again.
View ArticleRe: RailRider Steps up & Delivers!
Thanks, buds, I'm glad you like the new sissy bar setup that I wanted. Looks really clean with no holes. I'm one happy camper. Thanks for letting me know about the buttons, RailRider. I'm glad I had...
View ArticleRe: RailRider Steps up & Delivers!
Can you show How you put the bullet into the end ? Are your bullets metal ?
View ArticleRe: RailRider Steps up & Delivers!
Well, Al, I can try to explain it to you, don't have any pics of how I did it. I should take pictures of stuff that I do like that though, thanks for making me think about it. Yes, they are chromed...
View ArticleRe: RailRider Steps up & Delivers!
Kool, I would try doing it with a Car rim valve stem.I'll have to get some bullets from you sometime.sent a PM
View ArticleRe: RailRider Steps up & Delivers!
OK, Al, but you should know that most car valve stems don't do anything but cover the tip of the valve stem, so you would have to do too much stacking on the valve to make the valve go down far...
View ArticleRe: RailRider Steps up & Delivers!
Thanks, Jaxon. I appreciate your compliment. Just about worked my fingers to the bone to make those clamps. Ha!
View Article
